Bundle Voyager 1 Plasma Wave Spectrometer Waveform PDS Data Archive Entire Mission Planetary Plasma Interactions Discipline Node of the Planetary Data System This bundle contains the Voyager 1 Plasma Wave Spectrometer Waveform data from spacecraft event times 1978-08-21 to 2022-02-06, submitted to the Planetary Data System (PDS). Every effort has been made to assure that the data and documentation are of the best possible quality. However, mistakes are inevitable. The PPI Node of the PDS will maintain an online list of ERRATA where errors and updates are documented. Should any user of this product find an error on this bundle, please report the error to the PPI Node so that the finding can be made public. All users are encouraged to verify the "correctness" of the data prior to submitting any publications or other work based on these data. Users of these data are encouraged to acknowledge both the PDS and the principal investigators of the instruments whose data is used in analysis in all publications. ============================================================================== Dataset Description ============================================================================== Contents -------- The Voyager 1 Plasma Wave Spectrometer (PWS) raw full resolution data set includes all electric field waveform data for the entire Voyager 1 mission. Abstract -------- The Voyager 1 Plasma Wave Spectrometer (PWS) raw full resolution waveform data set consists of electric field waveform samples from the Voyager 1 Plasma Wave Science waveform receiver obtained during the entire mission. Data will continue to be added to the archive via updates to this bundle. The data set encompasses all waveform observations obtained in the cruise mission phases before, between, and after the Jupiter and Saturn encounter phases as well as those obtained during the two encounter phases. Data for this data set are acquired from the PWS waveform receiver. Data are presented as time series of 4-bit voltage measurements acquired at the rate of 28,800 samples per second through a 40 Hz to 12 kHz bandpass filter. An automatic gain control is used to keep the signal within the usable range of the 4-bit digitization, however, the gain information is not returned to the ground, hence, there is no direct, absolute calibration. However, a power spectrum analysis returns a spectrum that has accurate relative amplitudes between spectral elements. This data set provides the highest temporal resolution data from the Voyager mission. Citation -------- Kurth, W.S., and C.W. Piker, Voyager 1 Plasma Wave Spectrometer Raw Waveform 60ms V1.0, NASA Planetary Data System, 2022. Overview -------- This data set consists of electric field waveform samples from the Voyager 1 Plasma Wave Subsystem waveform receiver obtained during the entire mission. Data after 2022-02-06 will be added to the archive in subsequent releases. The data set encompasses all waveform observations obtained in the cruise mission phases before, between, and after the Jupiter and Saturn encounter phases as well as those obtained during the two encounter phases. The Voyager 1 spacecraft travels from Earth to well beyond 100 AU over the course of this data set. To provide some guidance on when some key events occurred during the mission, the following table is provided. Date Event ---------- ------------------------------------------------- 1977-09-05 Launch 1979-02-28 First inbound bow shock crossing at Jupiter 1979-03-22 Last outbound bow shock crossing at Jupiter 1980-11-11 First inbound bow shock crossing at Saturn 1980-11-16 Last outbound bow shock crossing at Saturn 1981-02-20 10 AU 1983-08-30 Onset of first major LF heliospheric radio event 1984-06-19 20 AU 1987-04-08 30 AU 1990-01-09 40 AU 1992-07-06 Onset of second major LF heliospheric radio event 1992-10-10 50 AU 1995-07-14 60 AU 1998-04-18 70 AU 2001-01-25 80 AU 2002-11-01 Onset of third major LF heliospheric radio event 2003-11-05 90 AU 2004-12-16 Termination shock crossing 2006-08-16 100 AU 2009-05-31 110 AU 2012-03-16 120 AU 2012-08-25 121 AU Heliopause crossing 2015-01-01 130 AU 2017-10-20 140 AU 2020-08-09 150 AU 2023-05-31 160 AU 2026-03-23 170 AU 2029-01-12 180 AU Sampling -------- The waveform is sampled at 4-bit resolution through a bandpass filter with a passband of 40 Hz to 12 kHz. 1600 samples are collected in 55.56 msec (at a rate of 28,800 samples per second) followed by a 4.44-msec gap. Each 60-msec interval constitutes a line of waveform samples. The data set includes frames of waveform samples consisting of up to 800 lines, or 48 seconds, each. The telemetry format for the waveform data is identical to that for images, hence the use of line and frame as constructs in describing the form of the data. For data acquired after the Jupiter flyby, these data are recorded on the digital tape recorder (DTR). After 1993, only every fifth line is returned in telemetry. The reason for this is that the maximum downlink rate supported by the Voyager-to-DSN link is 1.4 kbps while the minimum playback rate of the DTR is 7.2 kbps. Hence, as one line is telemetered to the ground, the following four are lost. Clearly, this results in a decrease in temporal resolution to 300 ms between lines and a resulting decrease in signal to noise ratio that might be achieved by averaging spectra across the 48-seconds spanned by the frame. Processing ---------- Because there is no direct method for calibrating these data and because a single byte per measurement is a convenient storage format, these data are stored as small integers. The raw ADC values (0 to 15) have been scaled using: RAW * 2 - 15 and thus all data values are in the set: (-15, -13, -11, -9, -7, -5, -3, -1, 1, 3, 5, 7, 9, 11, 13, 15) Since the instrument was tuned to produce raw values of either 7 or 8 on even a slight departure from a null voltage differential, 0 on this scale represents a null measurement, even though zeros are not present in the product files due to the quantizing effects of analog to digital conversion. The data may be plotted directly to show the actual waveform; this is useful for studying events such as dust impacts on the spacecraft. But the normal method of analyzing the waveform data is by Fourier transforming the samples from each line to arrive at an amplitude versus frequency spectrum. By stacking the spectra side-by-side in time order, a frequency-time spectrogram can be produced. Dynamic Range and Calibration ----------------------------- The waveforms are collections of samples of the electric field measured by the dipole electric antenna and the 4-bit samples provide sixteen digital values of the electric field with a linear amplitude scale, but the amplitude scale is arbitrary because of the automatic gain control used in the waveform receiver. The instantaneous dynamic range afforded by the 4 bit samples is about 23 dB, but the automatic gain control allows the dominant signal in the passband to be set at the optimum level to fit within the instantaneous dynamic range. With the gain control, the overall dynamic range of the waveform receiver is about 100 dB. The automatic gain control gain setting is not returned to the ground, hence, there is no absolute calibration for the data. However, by comparing the waveform spectrum derived by Fourier transforming the waveform to the spectrum provided by the spectrum analyzer data, an absolute calibration may be obtained in most cases. Interference ------------ There has been no attempt to clean various interference signals from the data. Most of these can normally be easily seen in frequency-time spectrograms as narrowband, fixed-frequency tones. The most common include narrow-band tones at 2.4 and 4.8 kHz which are power supply harmonics. There is sometimes a tone near 1.7 kHz which is associated with the operation of the spacecraft gyros. The spacecraft tape recorder results in a rather intense band in the frequency range of a few hundred Hertz. There are few times when the data in this frequency range can be used. However, there are times when the real signals in this frequency range can exceed the intensity of the interference sufficiently so that the frequency range near a few hundred Hz can be used. Use of the spectrum analyzer data can be of use to determine when these time periods occur. The stepper motor of the LECP instrument also interferes in the frequency range of a few hundred Hz, but for periods of a few seconds. The LECP interference is very intense and captures the automatic gain control so that real signals, even where there is no interference, will appear to decrease in amplitude until the LECP interference fades in amplitude. The PLS instrument periodically interferes at 400 Hz and odd harmonics because of a 400-Hz square wave used to modulate a grid in the detector. The PLS interference lasts for several seconds and ends abruptly. Telemetry errors result in a fairly graceful degradation of the waveform data. Assuming the telemetry errors are randomly occurring bursts, they typically appear as an enhanced background level in the spectrum. Since the bursts are short, their Fourier transform is a broadband spectrum. When looking for relatively narrowband features or features with distinct frequency-time characteristics, the result of the bursts simply reduce the signal-to-noise in the spectrum. One way of reducing the effect of burst telemetry errors is to pass the waveform data through a low-pass filter to despike it, prior to running the Fourier transform. Coordinates ----------- The electric dipole antenna detects electric fields in a dipole pattern with peak sensitivity parallel to the spacecraft x-axis. However, no attempt has been made to correlate the measured field to any particular direction such as the local magnetic field or direction to a planet. This is because the spacecraft remains in a 3-axis stabilized orientation almost continuously, and these data are not obtained during the infrequent calibration turns. Furthermore, the automatic gain control feature would tend to counteract any orientation-dependent amplitude variations. ============================================================================== Bundle Description ============================================================================== Key things to know when using this bundle: * Specific information about a data file *.cdf is found in the same directory in the label file *.xml. * Data files are in uncompressed CDF (Common Data Format) and follow ISTP (International Solar-Terrestrial Physics) metadata guidelines for each record, though there is a second time field for the offsets between waveform samples in a record. * All files are stored in the "data" directory tree by hourly SCET (SpaceCraft Event Time) coverage periods. Thus, for example, all data for SCET hour 2020-03-16T21:00 to 2020-03-16T22:00 are in a the product file "vg1_pws_wf_2020-03-16T21_v0.9.xml" * Voyager PWS waveform data are sparse, especially during interplanetary and interstellar cruise. Most hourly files in these regions will only have around a minute or two of regularly sampled field values. This is normal. On the other hand, near planetary encounters PWS was operated with a much higher duty cycle. * As detailed above, Voyager PWS waveforms are scaled using an onboard AGC and the AGC states are not transmitted to the ground. These data are uncalibrated. * Apart from this file, most of the relevant information about the Voyager mission and the PWS instrument are contained in PDS "Context Collections" and are only referenced here by their PDS logical identification (LID). Relationship to Other Bundles ----------------------------- The data on this disk are Voyager Plasma Wave Spectrometer Waveform Data which are the highest resolution wave information available from the Voyager Plasma Wave Receiver. Since they require very high data rates these data are only available for short periods of time with a low duty cycle. Low resolution spectrum analyzer data which are available for all times during which the Plasma Wave Receiver is on and telemetry is available are found in the bundles: urn:nasa:pds:voyager1.pws.sa urn:nasa:pds:voyager2.pws.sa which are available elsewhere within the Planetary Data System. An older version of this data set resides in the PDS, archived under PDS3 standards: VG1-J/S/SS-PWS-1-EDR-WFRM-60MS-V1.0 https://doi.org/10.17189/1519903 Software -------- Many common CDF aware tools may be used to read the data product files. Even though the PDS labels are the authoritative source of metadata about each product, the product files also contain full ISTP metadata for use by non PDS4 applications. Contents and Structure ---------------------- Below is a tree diagram of the volume, followed by a description of the directory function and key files in each directory. [voyager1-pws-wf] Root directory | |- [data] Contains the data collection definition as well as | yearly subdirectories of data product files. | |- [index] Contains an index of PDS label files for all data | archived on this volume and on the volume set to | date. | |- bundle.xml A PDS structure defining the bundle. | |- readme.txt Describes bundle contents, organization, and use (this file). Contacts -------- The person most directly responsible for the release of this bundle is Joe Mafi. He was the PPI Node Data Administrator at the time this bundle was drafted as much about the structure and data organization as anyone. Other PPI personnel who may be aware of issues related to this volume include Dr. William Kurth and Dr. Raymond Walker, the PDS/PPI Node manager. For questions or problems regarding this volume, please contact the PDS/PPI PDS operator: Internet pds_operator@igpp.ucla.edu Telephone (310) 206-6073 PDS Operator c/o Dr. Raymond Walker For questions regarding PDS Standards or other volumes available from the PDS, please contact PDS Operator at the PDS Central Node (at JPL): Internet pds_operator@jpl.nasa.gov Telephone (818) 354-4321 Planetary Data System, PDS Operator Jet Propulsion Laboratory Disclaimer ---------- The PDS and the Planetary Plasma Interactions (PPI) Node in particular, assume no legal liability for errors on this disk. All users are encouraged to verify the "correctness" of the data prior to submitting any publications or other work based on these data. Errors on this disk should be reported back to the PPI Node of the PDS via the contacts above. All trademarks are acknowledged as the property of their respective owners. The producers and publishers of this archive do not endorse any commercial entities which may be mentioned for clarity. ============================================================================== Acknowledgments ============================================================================== These data were collected under the auspices of the Voyager Project. Fred Scarf, Donald A. Gurnett, and William Kurth have been the Plasma Wave Spectrometer Principal Investigators. The archiving effort at The University of Iowa was coordinated by W. Kurth and supported by C. Piker and L. Granroth. This archiving effort was supported by the Planetary Plasma Interactions Node of the Planetary Data System. Assistance was provided by J. Mafi and D. Kazden of the University of California, Los Angeles.