Trigger 42 Description

Sequence: C34, C35
Trigger 42 ( 10 KHz WBR cyclic turn-on)

This trigger is designed to overlay 10-KHz Wideband Receiver data on top of a standard background trigger, such as 8A (Survey), 8E (night-time survey), or A0 (SEDDF). Data acquisition continues for all receivers, with the exception of the dust detector and the sounder, which are disabled during this trigger's operation. In addition, the MFR is switched to the EZ antenna to avoid interfering with the WBR, which is assumed to be connected to the EX antenna. It is assumed that the WBR is pre-configured before this trigger is executed, except that the 10-KHz band selection is done by the trigger. The standard setup done for the WBR by the background triggers is detailed below.

Receiver Frequency Range Sensor Time between Snapshots Samples per Snapshot
WBR 0 - 10 KHz EX 0.150 seconds 2048
MFR 25 - 12 KHz EZ, BZ 32 seconds


Other notes:

This trigger produces a maximum data rate of about 131 kbps. If the Telemetry Mode is S&ER-3, the data is limited to 60,928 bps.

There is a 60-second delay following the execution of this trigger, and preceding the start of the WBR data acquisition. This allows time for the MFR to switch antennas and the sounder to finish any pending operation.

This trigger will work with most non-direction-finding triggers, such as Trigger 28 (Interplanetary Cruise).